12kW inverter installation

How do you mount a 12kpv inverter?

Ensure the inverter is mounted upright. Do not mount the inverter at a >90° angle, or upside down. See image below. The 12kPV is designed to be wall mounted using a wall mounting bracket. The mounting location must be a vertical, solid mounting surface, such as concrete or brick, and be able to withstand the weight of the unit.

How to install an inverter?

d. The inverter should be installed upright on a vertical surface. Step1. Mark the drill holes positions with the mounting bracket, then drill four48mm(5/16inch) diameter holes, making sure the depth of the holes is deeper than 50mm(2inches). Step2.

How do you connect a power supply to an inverter?

connect it to the inverter. Insert AC output wires according to the polarities indicated on the terminal block and ighten the terminal screws. Be sure to connect the corresponding N wires and PE wires to the correct terminals and ensure the w ecurely connected.CAUTIONEnsure the AC power source is disconnected before attemp

How do I set up my envy solar inverter?

Battery and Load breakers are inside the Envy Wire Bay. PV disconnect switch is on the side of the Envy. Grid and Generator/AC coupled PV are external breakers. Turn on the battery system. Inverter will power up. Place the Inverter in Standby mode. When commissioning, measure the PV and assure there is no reverse polarity prior to turning on.

Can I export solar power from a 12kpv inverter?

Zero Export cannot prevent export of energy supplied by inverters that are AC Coupled to the 12kPV. Export to Grid: This selection is for users to set a zero-export function. If exporting solar power is not allowed, users need to disable the “Export to Grid” option.

How do I set up a PV inverter?

Ensure the PV string voltages are within the operating parameters using a multimeter. Upon confirmation, turn on (close) the PV isolator switch between the inverter and the panel array. Turn on (close) the PV isolator switch on the side of the unit. Make sure Steps 1 and 2 are accomplished before turning on the grid power or generator breaker.